Supreme Light Cure Custom Tray Material
Supreme LC is a material in the form of contoured plates for maxillae and mandibles.it is used for the fabrication of individual trays for crown & bridges and in a total prosthetic technique. it can also be used for the fabrication of bases for bite patterns and odontograms.
- The tray material is ready for use, easy to handle.
- Supreme LC can be cured under room and daylight (lengthy procedure), but cures quickly under halogen and UV light.
- The individual trays can be used directly after fabrication.
Optima Light Cure Custom Tray Material
OptimaLC is a material in the form of contoured plates for maxillae and mandibles.it is used for the fabrication of individual trays for crown & bridges and in a total prosthetic technique. it can also be used for the fabrication of bases for bite patterns and odontograms.
- The tray material is ready for use, easy to handle.
- OptimaLC can be cured under room and daylight (lengthy procedure), but cures quickly under halogen and UV light.
- The individual trays can be used directly after fabrication.
Motif Pattern Resin
Motif is a ımplant verification jig, light-curing resin for fabricating custom milled attachments using the casting technique.
- The material may also be used for intra- and extra oral splinting of cast units in preparation for soldering.
- The material is cured with light polymerization devices at a wavelength range of 400-500 nm.
- Motif can be applied directly from the dispenser and burns out without residue.
- The cured material can be used in conjunction with common casting waxes.
Zaferan Blockout Resin
Zaferan is a dimethacrylate based, blue shaded light curing gel like block out resin. Zaferan is used for the fabrication of bleaching tray, repair of laboratory models, fabrication of fluoride tray, blocking out of undercuts, fabrication of interim acrylic removable partials dentures and joining of dies. It is designed for only dental laboratory use.
Sumo Pink - Light Curing Bond Opaquer
Sumo pink is a light-curing paste opaquer for covering model casts with an integral adhesive component. Use of an additional bonding system is therefore unnecessary.
- The framework is worked as usual after casting.The surface is sand-blasted with aluminum oxide 50 - 110 μm, 2 bar, and blown off with oil-free pressurized air.
- Sumo pink is applied thinly with a firm short-haired brush. At least two coats are needed to obtain complete coverage.
- A non-covering opaquer layer has a negative effect on the shade.
- The flow characteristics of the opaquer can be optimized by mixing it on a mixing block.
Ultra Glaze
Provides High Quality Shine!
Ultra glaze is your best solution partner in finishing restorations with its strong effect and glossy surface.
Provides long-lasting shine and high wear resistance in all restorations.
İt is biocompatible
Cured under UV light.
- Saves time
- There is no need for a polishing stage because of curing.
- Easy use and application
- Thin coating layer (25-50 μm), lasting shine and long-term results.
